How to paint furniture by yourself
Step 1: polish: find a cuboid that can be grasped by hand. One of the flat side, with sandpaper wrapped, hand press after polishing. The direction order of polishing plane is: horizontal first then vertical. When grinding, first up and then down, first outside and then inside, the selection of sandpaper is first thick and then fine.
Step 1: polish: find a cuboid that can be grasped by hand. One of the flat side, with sandpaper wrapped, hand press after polishing. The direction order of polishing plane is: horizontal first then vertical. When grinding, first up and then down, first outside and then inside, the selection of sandpaper is first thick and then fine. The corner of furniture and modelling and detail place, have to use the hand. Why polish it? It is to take out the impurity on original paint and lacquer surface on the one hand, it is to increase the adhesion of new paint on the other hand.
The 2nd step, the preparation before brushing paint: after burnish is finished, see whether furniture has uneven place, if have, make level with be bored with child, burnish again to level off state. Then make protection around furniture and floor to prevent paint from contaminating these areas. Wipe the furniture with a lightly moistened towel. Stir bucket paint evenly with a small stick, the movement speed of the hand is not too fast, to prevent splashing.
The 3rd step, brush paint: when brushing woodwork paint for the first time, attune primer is a very important working procedure, attune primer knows the density of woodwork even, those more hard woodwork density is high, primer can attune a bit sparsely, and soft woodwork primer is about to attune a bit stickier. When beginning to brush lacquer, the grain besmear that should follow woodwork is brushed even, do not besmear too thick, after waiting for woodwork paint to be completely dry burnish with sandpaper, burnish feels smooth to you, it is ok to do not have protuberance, reoccupy next soft wet cloth is wiped a few times, wipe finally. And the use of brush coating can make the penetration depth of wood wax oil is greater, but also make the construction speed up.
The 4th step, brush 2 times lacquer: brush 2 times lacquer to be about to attune a bit sparse, after brushing, can cover the woodwork lacquer that brushes for the first time, follow the direction that brushes lacquer with the water sandpaper of 500 eye above next burnish, burnish should burnish evenly. Using a brush can save the amount of wood paint. Wait until the second paint or the last paint table dry, immediately wipe wooden surface with clean cotton cloth, make wooden surface becomes smooth.
The fifth step, brush three times paint: brush the third paint, to use more fine water sandpaper grinding, to dip in water grinding, grinding strength to uniform, should not be too heavy should not be too light. There is no need to polish after the last coat of paint, you can apply a coat of furniture protective wax. Add the number of wipe besmear, and every time finish with fine sandpaper burnish, the last time with thin wipe and table dry wipe can obtain the effect of high-grade furniture.
The sixth step, lacquer layer protection: normally furniture is brushed in besmear after finishing, want besmear to brush varnish, undertake protection to paint layer and add bright. Varnish also brushs a method consistent with paint besmear, paint brushs place to touch lacquer quantity nevertheless every time less, spread out varnish place swings the number of wrist also much again. Varnish recommended at least two times, if there is hair brush off the phenomenon, must be timely treatment of the hair, pay attention to the varnish only brush furniture surface not brush inside.
